“The Reviver results seem grey, not black. Why?”

Hi Sam, grey? Oh dear!

We are sorry to hear you are not satisfied with the results after using Renovo products. Our products are simple and effective with their application if all instructions are followed.

Of course if you were trying to change the colour of your soft top from a much lighter shade (i.e grey & black), of colour, you would need more than the recommended one or two coats but not more than three to achieve this.

If you have also added proofer to the top, or you feel you need to clean off the Reviver/Ultra Proofer using the Renovo Fabric Soft Top Cleaner, and start over. Follow these instructions:-

Mist spray the top and then paint on the Fabric Soft Top Cleaner leave the solution to dry for approximately one hour, this is the optimum time for the active ingredients to work. Using hand hot water the surface should then be scrubbed with a bristle brush being careful around stitched areas and windows. It is essential to use hand hot water!  Finish by rinsing off with water. Repeat the whole process as necessary.

I hope this was helpful to you and of course if you have any further questions, please do not hesitate to contact us, or take a look at our “archive” section for all previously asked questions.

Don’t forget all of our products are available for purchase via our website, visit:

Add a Comment

Your email address will not be published. Required fields are marked *