Ultra Proofer - Application instructions
Buy Now
Please note: It
is advisable to test on an inconspicuous area of your convertible top prior to use, as some
colours may appear lighter or darker after application.
Do not apply in direct sunlight, as this will cause the Ultra Proofer
to dry out too quickly and produce an uneven result.
- Dry brush the soft-top to remove any loose dust/dirt.
- Pour Ultra Proofer into a suitable container/bowl.
- Stir well before application.
- Apply Ultra Proofer with a new 5cm/2inch paintbrush
ensuring that the fabric is completed wetted out. It is best
to commence application in the centre of the soft-top and as
quickly as possible progress towards each side, the front and
the back of the soft-top. Wipe excess drips from paintwork,
trims and glass with a damp cloth.
Depending on the condition of the top a litre
of Ultra Proofer is usually sufficient for two coats on an average
size soft-top. It is important to allow Ultra Proofer to dry between
coats. Always ensure that you have enough Ultra Proofer to coat
the soft-top completely and that you will not run out half way
through application!
- Allow the top to dry for approximately three
hours, this will depend on the drying conditions. The Ultra
Proofer may dry out more quickly if it is a warm day and may
take longer to dry if it is a damp day.
- Wash out brush in warm, soapy water.
Do not take car out in rain/wet weather until
the Ultra Proofer has completely dried.
The soft-top is now water and stain repellent, will resist the growth
of mould/mildew and is protected from harmful Ultra Violet rays.
To ensure best possible weatherproof protection we advise that Ultra
Proofer is applied every six months. |
